#4
|
||||
|
||||
I just don't understand how this can be, Marco_Polo. I'm looking at the code here, and it calls the onBeforeRunningCopy before it runs the backup (which loads the settings). The only way I can see it doing otherwise is if the "default" settings (the configuration it'll start up with normally) references the same disk.
As far as the image goes, if your source volume is 250GB, the most the sparse image can grow to is 250GB, since that's set as it's maximum size...
__________________
--Dave Nanian |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Fw Drive Wont Boot | Budgie | General | 3 | 11-05-2006 01:22 PM |
Backing up _FROM_ a SMB/CIFS server? | TheAbbott | General | 1 | 03-10-2006 02:42 PM |
Problems with SD | fdwlaw | General | 8 | 01-15-2006 10:58 AM |
Backing Up Server | digitalclips | General | 1 | 07-11-2005 02:59 PM |
AirPort base station as server: can't connect! | dnanian | General | 0 | 01-03-2003 11:48 AM |