Shirt Pocket Discussions  
    Home netTunes launchTunes SuperDuper! Buy Now Support Discussions About Shirt Pocket    

Go Back   Shirt Pocket Discussions > SuperDuper! > General

Thread Tools Rate Thread Display Modes
Prev Previous Post   Next Post Next
Old 03-11-2010, 05:42 PM
sgmorr sgmorr is offline
Registered User
Join Date: May 2007
Location: DFW area of Texas
Posts: 16
Problem Booting From a Clone on a Firewire HD

This is a bit of a complicated question. I use SuperDuper to make and maintain a bootable clone of my iMac's HD on my OWC Mercury Elite 1 TB peripheral HD connected with FW 800. Works fine. After updating my clone weekly (I also use Time Machine daily just to be clear about my backing up!), I usually do a test boot from my clone by selecting "restart" and then holding "option" at the gong until I get to the screen that gives my a choice between Mac HD and Clone. So far, so good. Works every time.

Today, I got the idea to try booting from Clone starting with my iMac being shut down. My OWC was powered on of course. So I powered my iMac on with the power button, then held "option" at the gong and it took several minutes for start up to occur. I never did get the screen giving me the choice of Mac HD or Clone, but finally arrived at my Desktop (several minutes longer than a usual start up).

Curiously, I went to the Apple menu and chose "about this Mac" and the little screen showed Mac OS X, the processor, the memory, but it DID NOT show the startup disk as it usually does. Usually, of course, it will show startup disk as "Mac HD" and if I'm booted from my clone, it will show startup disk as "Clone."

I thought this was curious so I just did a standard restart again (without holding "option") and all I ever got was a solid gray screen after five minutes. I was a bit shaken but I finally decided to depress the power button and the iMac shutdown. I disconnected my FW drive for good measure and powered my iMac back up and it started normally. I verified my internal HD with Disk Utility and it was fine. I reconnected my FW drive, it mounted normally on my Desktop and I successfully booted from it by restarting and holding the "option" key.

Question: did I not follow correct procedure in attempting to startup from my FW clone when my iMac was powered off initially? Should this be possible? After all, you would want to be able to do this if your internal HD had failed, correct?

Seems like I was able to do this with my old G4 iMac, Tiger, and a peripheral clone just fine.
Reply With Quote

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
Thread Tools
Display Modes Rate This Thread
Rate This Thread:

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Problem Snow : Failed to enable ownership on Clone ! Bruno_08 General 3 09-02-2009 06:14 PM
Windows equivalent to SuperDuper!? jreffner General 21 08-13-2009 05:36 PM
Booting and Running from External HD clone jlecks General 1 01-09-2008 07:52 PM
Problem getting apps to run on clone volume ChetA General 3 09-06-2005 02:19 PM
Booting with Safety Clone? dgboat General 5 07-14-2005 12:12 PM

All times are GMT -4. The time now is 07:38 AM.

Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2024, vBulletin Solutions, Inc.