SuperDuper! not loading on Lion

[southwos]

Just updated to Lion and when I try to run SuperDuper! it starts to load then just goes away, no message, no error box. Any suggestions?

[dnanian]

Make sure you've updated to the current release, 2.6.4 (downloadable from the SuperDuper! page).

[southwos]

Originally Posted by dnanian

Make sure you've updated to the current release, 2.6.4 (downloadable from the SuperDuper! page).

I have downloaded 2.6.4 and it does load now. However now I cannot select other drives. Let me explain, let's say I have a drive named drive1 as my main HD and drive2 as my backup. I select drive1 as my source drive and the drop down shows all my other drives, but the only one that is available to select is drive1 all the other available drives are greyed out.

[dnanian]

Sounds like they're not formatted for the Mac (HFS+) but are rather formatted for Windows.

[southwos]

Originally Posted by dnanian

Sounds like they're not formatted for the Mac (HFS+) but are rather formatted for Windows.

No Sir, they are HFS+ drives, I have been using SuperDuper! for at least 4 years and have had no problems. I'm not suggesting this is a Shirt Pocket problem, but maybe a Mac Lion issue. these are two drobo boxes that have been working without issue for the past two years with SuperDuper! Since my upgrade to Lion I have had this issue. I'm just wondering if anyone else has had an issue. I'm willing to try anything to get SuperDuper! to work. I can see and use both Drobo's with Lion, I just cannot select source and target drives like I use to with Snow Leopard.

[dnanian]

We only disable drives if they:

- Are read-only
- You're running from them (disabled as a destination)
- They're not formatted as HFS+

Otherwise, perhaps you need to try to restart your Mac? That's what I'd try.