Stalled copy on MacbookPro
I have a Macbook Pro running 10.4.7, with FW 800 drives attached to a NitroAV cardbus card--lots of variables I know! I have SD 2.1.3 and I'm running into this issue:
If one of the drives I want to clone is on the NitroAV bus then SD goes through the erasure and mounting steps fine, but then hangs and 0 files out of 163 (how many are on the drive) examined and 0 files copied at 0 speed etc. I let it go for 30 minutes and it didn't change. When I try to quit I get the message that it's not finished and it could leave the destination drive in an unstable state. If I quit and try to eject the drives or shutdown I get a kernel panic.
Any thoughts?
SD works fine going from the internal HD to an external via the built in FW.
Thank you.
|