![]() |
|||||||||||
![]() |
![]() |
![]() |
![]() |
![]() |
![]() |
![]() |
![]() |
#1
|
|||
|
|||
Sparce Image fails to umount
Backing up my Powerbook to a Firewire hard drive. Everything goes fine until the very end and then I get this error in the log. (see below)
The sparceimage is still on the firewire drive after manually dismounting it. How can I correct this error and is the manually dismounted sparceimage still usable? Thx. |10:20:19 AM|Info| PHASE: Conclude Target Setup |10:20:19 AM|Info| ...ACTION: Finalizing "Powerbook.dmg" session |10:20:19 AM|Info| ......COMMAND => Unmounting /Volumes/Large Marge/Powerbook.dmg from /tmp/SVUmount |10:20:23 AM|Info| hdiutil: couldn't unmount "disk2" - error 49153 |10:23:57 AM|Error| rm: /tmp/SVUmount: Resource busy |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
SuperDuper Backup of AES 128 Encrypted Disk Image | rwg4 | General | 3 | 11-30-2005 10:28 AM |
Sparse image mounted over network is grayed out in backup destination list | therevolution | General | 5 | 06-25-2005 07:49 PM |
Image restore ends with an error | adamd | General | 3 | 06-22-2005 09:50 AM |
Question regarding backing up to Image | giba | General | 3 | 05-20-2005 05:54 PM |
How do I update an image? | dnanian | Frequently Asked Questions | 0 | 06-12-2004 10:05 AM |