Shirt Pocket Discussions  
    Home netTunes launchTunes SuperDuper! Buy Now Support Discussions About Shirt Pocket    

Go Back   Shirt Pocket Discussions > SuperDuper! > General

 
 
Thread Tools Rate Thread Display Modes
Prev Previous Post   Next Post Next
  #1  
Old 12-23-2009, 09:06 AM
MacNovice MacNovice is offline
Registered User
 
Join Date: Feb 2008
Posts: 5
Event status codes?

Need to know what SuperDuper can do to help me in the following task. I need to clone a Mac Mini Server boot disk daily (weeknights only) to an external drive.


Part A
I don't need help scripting the task but I need to know how SD can signal status of the backup process to the task/script I write.

I need to write a script that will:

a) Log users out at a specific time of day (no problem doing this)
b) Ensure that certain encrypted .dmg's are properly closed/handles released (no problem doing this)
c) Shutting down SMB services (no problem doing this)
d) Start an unattended SD clone backup session (no problem doing this - I hope)
e) Get status on whether the SD backup has successfully completed or failed (need to know how to get this status from SD)
f) Restart SMB services if backup is successful (should be no problem to do this).

So in a nutshell, how do I get info from SuperDuper which will enable me to do Step e). ?


Part B
The backup/clone will run nightly but here's the wrinkle - there will be 5 different external drives used for the cloning process - a different drive used each weeknight. These drives will be rotated off-site daily as part of a disaster recovery process to ensure that data is not lost due to fire/theft of the server.

In some readings in this forum I have seen that SD creates a unique drive ID for each drive and this may impair the ability of my backup script to handle the use of different target drives each weeknight.

One solution would seem to be to have a different script for each day of the week which uses the same target drive, but that means that any backup script must be aware of a specific drive as the target, and would require maintenance if a target drive failed and was replaced with a different drive (brand/model).

Any thoughts on how to handle this in SD or my script so that just one script can be used irrespective of the drive employed as the target drive each night?

Thanks
Reply With Quote
 


Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 
Thread Tools
Display Modes Rate This Thread
Rate This Thread:

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Apple Event Timed Out lotec General 13 08-04-2009 12:11 PM
Backup Status reports more "up to date" data than exists?? binaryeric General 1 07-07-2008 12:47 PM
Odd Event when backing up Circe525 General 1 01-17-2008 07:50 AM
Status of copy in an "after copy" bash script? acronce General 4 01-07-2008 01:05 PM
Scheduled Backup Status ElNormo General 1 04-21-2006 11:30 PM


All times are GMT -4. The time now is 01:44 AM.


Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2019, vBulletin Solutions, Inc.