 |
 |
 |
 |
 |
 |
 |
 |
|
|||||||||||
|
|
|
|
|
|
|
|
|
#1
04-20-2008, 01:47 AM
|
|||
|
|||
|
No boot on new PM Quad core...
Have a SATA 'Cuda installed on internal disk bus and cloned a system disk to the drive. Start disk control panel recognizes the cloned drive and the system folder and allows selection, but when I try to boot it always goes back to the factory system drive. I'm going to try an install from the OSX DVD to see if it will at least boot from the drive. Brand new system, 10.5.2.
Other suggestions? 
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| SD 2.5 - Clone disk hangs on boot | ashkit | General | 12 | 02-11-2008 09:41 AM |
| Boot Problems on LaCie Firewire Drive | michael k | General | 10 | 11-06-2007 02:33 PM |
| Will Core Duo clone work on Core 2 Duo? | randyharris | General | 2 | 08-23-2007 01:13 PM |
| First Boot Experience, Seagate 400GB PushButton FW Works! | greenjeens | General | 5 | 05-25-2006 07:19 AM |
| Upgrade from iMac to Quad G5 | Piggy | General | 5 | 01-05-2006 03:14 PM |
Threaded Mode