[Loopy C]

I am on my third update of a cloned drive. This third time the back-up gave the error 'failed to copy files' because drive had exceeded capacity while using Smart Update? There is now only 58 MB left on the destination drive. I thought the drive was made to look like the source, erasing and updating. How did I fill up the destination if I have only used Super Duper on it (again, I erased drive, created clone, and have updated two times before this).

Internal Source Drive: ATA Drive 120 (111.8 GB)

This drive (system drive) has about 7 GB free

Destination Drive: Lacie Firewire 120 (111.8 GB)

Now only 58 MB free after failing to finish update (and I definitly saw the 'Smart Update' message before starting operation)

OSX 10.4.5 / Powerbook 17 HR 1.67 / 2 GB RAM

Thanks in advance.