During Smartbackup, the info won't update !
1 Attachment(s)
Hi Dave,
Recently I discovered that during a SmartBackup, the info on the #2 Copy Files, you know, the status bar and the "files evaluated and "copy speed" - in fact all the numbers that appear there, will update to a certain point before halfway of the process and then ALL this info suddenly stops updating, BUT the process continues and the back up completes succesfully. I am including an attachement for you to look at what point the updating of the info stops. Thanks for your attention. Enrique Diazruanova |
We're aware of this happening on some 10.4.11 Intel systems: does that correspond to yours? Does it happen consistently?
|
Quote:
Yep, that is my case and I have noticed it on the last two back ups. Maybe it appeared before, but since I do not monitor the process it was 'till yesterday-and today that I repeated the back up- that I was aware of it, and yes, it happens consistently... so the question is there anything to worry about the quality of the back ups? I already booted from the back up drive and ran Apple's Disk Utility and Drive Genius on it and so far so good! so...? Enrique Diazruanova |
No, your backups should be fine, but drop me a note to support with your most recent log (use "Send to shirt pocket") so I can take a look.
|
Quote:
Enrique Diazruanova |
All times are GMT -4. The time now is 12:09 AM. |
Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2024, vBulletin Solutions, Inc.