Shirt Pocket Discussions  
    Home netTunes launchTunes SuperDuper! Buy Now Support Discussions About Shirt Pocket    

Go Back   Shirt Pocket Discussions > SuperDuper! > General

 
 
Thread Tools Rate Thread Display Modes
Prev Previous Post   Next Post Next
  #1  
Old 09-01-2005, 08:49 AM
mcthomas mcthomas is offline
Registered User
 
Join Date: Jul 2005
Posts: 13
Identifying Startup Disk

Good morning Dave:

The "Backup All Files" on my G4 PowerMac to a Lacie 120 gig FW Drive (four partitions) went without a hitch. About 30 minutes for 10 gigs to be copied. The system rebooted using the clone (MacTavish) which was named the same as the primary system disk (MacTavish) pursuant to some of the advice regarding aliases as given in this forum.

Now have booted back to the primary MacTavish in order to set up the safety clone. Have tried many ways to tell the primary HD from the clone - no luck.

The reality of a clone is obvious when looking at the startup disk options in system preferences. Two Tigers and Two Classics. The first option is obviously active. Is it the Mac original or the Lacie clone. Is there some other source in preferences or elsewhere to determine when an application is the active one? When system preferences is open get info is closed.

Am concerned that if future mistake is made in identifying the startup disk and clone is used (inadvertently) as source either in effort to produce the safety clone or a smart update the "Erase" feature will zap my primary system.

Considering the smarts that went into Super Duper's development I suspect that somehow the ability to smart update or produce the safety clone when the clone was used as the source (was the startup disk) is stopped - but I don't want to take the chance until i can know for sure.

In short, any known ways to tell the difference between the primary and the clone of a full backup so that I can be sure that the clone was not used as the startup disk - except as recalled by my senior citizen memory.

Again, thanks for this great software and the willingness to support it's users as you do.

Mcthomas

PS Just thought of a possible work around. I think that showing the Lacie partitions on the desktop will allow changes in the partition name. Now that the full backup is in place would a name change affect the smart update or restore capabilities? I suspect so based on gleanings from this forum.
Reply With Quote
 


Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 
Thread Tools
Display Modes Rate This Thread
Rate This Thread:

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
SuperDuper Backup of AES 128 Encrypted Disk Image rwg4 General 3 11-30-2005 10:28 AM
Disk Utility problem after cloning macWish General 38 10-01-2005 01:08 PM
Disk errors repoted using SD yet Disk Utility works fine. s_dup General 5 08-22-2005 08:02 AM
Transferring to a new startup drive dzevans General 8 02-27-2005 07:17 PM
Sparse Disk Image track record? Phil General 3 01-05-2005 01:45 PM


All times are GMT -4. The time now is 06:05 AM.


Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.