|
#1
|
|||
|
|||
Main Panel Stops Updating, But Target Drive Gets Filled Up
My copy progress bar hasn't budged in hours, but when I Get Info on the target drive, the Used bytes are still filling up.
Should i just wait until the "Used ... on disk" in my Get Info for the target matches that of the source drive and then stop the operation within the SuperDuper! panel, or am I screwed somehow? |
#2
|
|||
|
|||
To update this: when the Get Info matched the source drive, the copy process within SuperDuper seemed to get the idea and automatically updated, proceeded to make my target bootable and restored the Spotlight.
So, even though the progress readout failed to update any further, the overall process was still managed correctly. |
#3
|
||||
|
||||
This is a known issue on some Intel Macs on OSX 10.4.11 -- happens intermittently, corrected in the next update.
__________________
--Dave Nanian |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Windows equivalent to SuperDuper!? | jreffner | General | 21 | 08-13-2009 05:36 PM |
Can I switch to use the backup clone as the main drive? | derekw | General | 1 | 08-02-2008 07:10 PM |
Migrating from one hard drive to another | zestyping | General | 3 | 07-25-2008 08:22 AM |
Best process to replace internal hard drive using SuperDuper!? | emikysa | General | 26 | 02-09-2007 05:03 PM |
Long Hang While Copying | BackerUpper | General | 4 | 06-12-2006 08:26 AM |