[suburbiaboy]

Hi,

I made a read only disk image (it's a computer I'm getting rid of so no longer need to incrementally backup) which seemed to get stuck at the last stage – Converting to read only.

The phase 2 backup to a USB drive took about 7 hours (458GB) and I stopped the process after 9 hours of converting to read only as nothing seemed to be happening and the progress bar was at complete.

I'm left with filename.dmg.sparseimage (452GB) and filename.dmg (398GB).

Before I start over, had that likely failed? Or was I being impatient? Logs are attached.

Thanks,
Jamie