gianfri
03-17-2008, 10:54 PM
I just got this Buffalo NAS, connected to the AEBS through Ethernet, set it up in RAID0 mode. I can connect to the NAS through the finder by using SMB://192.168.2.9. The unit is then mounted on the finder with the label 192.168.2.9.
I then start SD! and try to create a sparse image and save it on the NAS unit but the unit does not appear on the SD! list of target in the WHERE list.
How can I have SD! detect this unit?
Thank you,
Gianfranco
I then start SD! and try to create a sparse image and save it on the NAS unit but the unit does not appear on the SD! list of target in the WHERE list.
How can I have SD! detect this unit?
Thank you,
Gianfranco